1
00:00:00,670 --> 00:00:08,290
That would require a telnet client enabled on my P.C. scrolling down I can see as an example that the

2
00:00:08,290 --> 00:00:15,570
polling method used for those devices is an MP and the polling interval is 120 seconds.

3
00:00:15,660 --> 00:00:19,560
I can see as an example the interfaces and the state of those interfaces.

4
00:00:19,830 --> 00:00:27,630
We can see other information about the device including that it was rebooted let's have a look at router

5
00:00:28,110 --> 00:00:30,760
to see his routing too.

6
00:00:31,080 --> 00:00:32,810
We can see information about the node.

7
00:00:32,850 --> 00:00:39,940
Once again that it's up we can see that it's being polled with S&P we can see the interfaces once again.

8
00:00:39,950 --> 00:00:47,210
So let's have a look at serial zero slash a zero in this case we can see the utilization isn't very

9
00:00:47,210 --> 00:00:53,140
high on this interface because no traffic is being sent and we can see that the interface is up she

10
00:00:53,180 --> 00:01:02,530
has rotted to interface serial zero slash zero that's the interface that we're looking at in NPM I'll

11
00:01:02,530 --> 00:01:11,300
shut this interface down interfaces gone down I'll click pull and now and as you can see the interface

12
00:01:11,300 --> 00:01:19,740
is being shut down that interface has gone down in wires shock we can see that a message was sent from

13
00:01:19,740 --> 00:01:30,330
NPM to the router and the router then responded with information about the O I.D. on the device so let's

14
00:01:30,330 --> 00:01:38,340
do that again what I'll do is restart the capture we're going to search for S&P and I'm going to specify

15
00:01:38,340 --> 00:01:45,600
an IP address 10 dot wondered one hundred or two so we can see requests from the management station

16
00:01:46,140 --> 00:01:54,200
and then responses back from the rudder what I'll do now is no shut the interface so bring it up so

17
00:01:54,270 --> 00:02:03,360
I'm bringing up serial zero slash zero back in the management interface I'll click poll now and notice

18
00:02:03,360 --> 00:02:13,110
there are no values for different ideas and now responses are coming back from the rudder pole again

19
00:02:13,830 --> 00:02:22,380
interfaces up so it was done previously so the NPM device is able to retrieve status information of

20
00:02:22,710 --> 00:02:30,540
network interfaces by using S&P we can see for instance the speed of the interface utilization and other

21
00:02:30,540 --> 00:02:35,670
options on the interface of the rudder all running with ingenious three.