This is one of multiple videos discussing IP version 6 rotting in a previous video.
I configured these two rods to use static ip these six runs
using the local outgoing interface what I'll do in this topology is remove that several interface and
connect these rods using a Ethernet interface so at the moment to show IP these six interface brief
shows us that this address is configured on the serial interface.
So what I'll do is go into the serial interface and type no IP vs 6 address.
So now we don't have an IP vs 6 address configured on the serial interface.
I'll do something similar on the site no IP 6 address to show IP vs 6 interface we can see that the
loop back is configured with an IP vs 6 address but no other addresses have been configured on any interfaces
so what we'll do now is no shut the first Ethernet interface and configure the IP version 6 address
on the Ethernet interface so IP vs 6 address and the specific address show IP vs 6 interface
shows us that this interface is up up the link local address used.
Is this the global unique cost address used is this the router has joined all hosts on the local segment
and all routers on the local segment multicast groups and has joined some other groups as well.
Show IP vs 6 interface brief shows us the link local address as well as the global unique cost address
configured on the router show IP vs 6 round shows us connected rot and local rot.
Link local addresses are not added to the writing table.
We also see information for the loop back that was previously configured so on the site interface f
0 slash 0.
No shut IP the 6 address 2001 Column 1 Column column to slash 64 paying 2001 column 1 colon column 1.
Write it 2 is able to ping write of 1 using the fast ethernet interface show IP vs 6 round only shows
connected and local rates in the routing table and that's true on both borders.
Now a static round does exist in the running config but that's not used because the local interface
has gone down.
But what I'll do here
is remove that rot.
You can do the same on the site
so no IP vs 6 wrapped
to remove the root.
Show IP vs 6 rod again shows us that we only have local and connected roots in the writing table so
to allow writer to ping the loop back of write a one what we would do is type IP vs 6 round specify
the Destination Network which is 2001 colon face colon 1 colon colon slash 64 we can specify an interface
or the next hop IP address so the next top IP address is going to be 2001 colon 1 colon colon 1 and
we can specify and administer of distance for the right.
I'm not going to do that show IP vs 6 right.
We now have the static rot in the writing table and we should be able to paying 2001 colon face colon
1 colon colon 1 and we can can write a 1 ping the loop back of write it to not at the moment.
We have to configure a rat to so IP vs 6 rat 2001 face to slash 64 specified.
Next Top of 2001.
1 2 Can we paying two thousand and one face to 1.
Yes we can show IP vs 6 or branch shows us the static rot in the running table but in this example it's
via the next hop IP address same is true over here.
So that's different to the previous example where I configured the IP vs 6 static route using the local
outgoing interface of the router so that was an example of how to configure IP vs 6 static grants.
I hope you've enjoyed this video.
If it's been of benefit to you please like it.
And please subscribe to my YouTube channel.
I wish you all the very best.